The Pro Series

PATENTED- #5,769,593

$750.00 + S&H

BSE’s Pro Series ramping system consists of 65” main ramp sections that are single pieces of 6061-T6 extruded aluminum, the same alloy material used in the entire system. Each ramp is a 10” wide by 2” deep channel with a center support leg. There is a welded aluminum tube bracket on the front of each ramp by which the entire ramp system is attached to the rear of the trailer ramp door. There is a fabricated secondary ramp section hinged to the rear of the main ramp by heavy steel hinges that is 9 5/8” wide by 50” long. This section allows door cars with low to the ground and extended nose pieces to successfully load and unload without dragging. The secondary ramp, over a 50” span, goes from ground level to only 2 1/4” off the ground. This proven design combined with the ramp door adjustable extended bumper system (included with purchase) that raises the rear of the ramp door 5 to 7 inches will load virtually any bodied race car with no jacking of the trailer or lumberyard assistance. The overall length of each ramp is 120”. Due to the attachment design, the ramps are adjustable in seconds to fit any wheel base of any vehicle that will fit in the trailer and the ramps rotate 180 degrees fold up and lock to the trailer ramp door for safe transportation. All aluminum is hand polished and there is a nonskid strip running up the center of the ramps for safe wet weather loading. The kit includes all hardware to complete the installation and detailed instructions with illustrations. The shipping weight of the ramp system is 91 pounds and ships via UPS in one box. Installation time is 1 hour.

Our ramping system designs are protected by Patent # 5,769,593. Any and all instances of infringement on our patent rights have been investigated and litigation pursued in the past if the situation warranted it. This policy will continue.